Form opposite RR#9, cut lightening holes in RRs #8 & #9 both sides.
5.27 hours.
Related Posts
Cutting 0.040 Sheet
- Glenn
- March 2, 2008
- 0
Continued cutting 40 thou sheet including main spar webs. These took about 25 runs with an Olfa P-800 knife and were a bit tricky to […]
Tie Down Rings, Torque Tube Bearing
- Glenn
- June 28, 2009
- 0
Cleaned up Aileron Bellcranks. Went ahead and made 6-W-9-1 Tiedown Rings, 6-B-17 Rear Torque Tube Bearing. 4.63 hours.
Wing Spars March 2010
- Glenn
- March 28, 2010
- 0
Date Job Start Time Finish Time Total Time Decimal 6/03/2010 Continue with spars- after doing somemore setting up, I took some photos and emailed them […]