Mark out and cut Centre Spar Caps. . I simply cut these with the hacksaw, mainly because it was quicker than dragging the table saw out from its’ cramped storage place. Finshed off the ends by hand filing.
2.27 Hours.
Related Posts
Cutting 0.040 Sheet
- Glenn
- March 2, 2008
- 0
Continued cutting 40 thou sheet including main spar webs. These took about 25 runs with an Olfa P-800 knife and were a bit tricky to […]
Rear Channels
- Glenn
- April 4, 2009
- 0
Firstly, apologies to anyone who may have been following my progress here. I have been very busy on the project, but simply haven’t found the […]