6-B-8 1 Gear Gussets Posted on December 7, 2008December 8, 2008 by Glenn Completed cutting out and bending Gear Gussets. See accompanying photos. 1.77 Hours. After cutting blanks, long flange is bent using extra width. Note holes for brake bolts to pass through. Trimming off the excess after bending. Drilling through the excess on the end flange. Checking for square before bending. Bend in process. The completed item
Fuselage Fuselage Form Blocks Glenn February 17, 2009 0 Instrument Panel & Middle Bulkhead form blocks marked out. 1.58 Hours.
Fuselage Standard Z Angles 6-B-1 Z Glenn December 7, 2008 0 Standard Z Angles 6-B-1 Z. I cut some blanks
Fuselage Wing Tie Down Rings, Torque Tube Bearing Glenn June 28, 2009 0 Cleaned up Aileron Bellcranks. Went ahead and made 6-W-9-1 Tiedown Rings, 6-B-17 Rear Torque Tube Bearing. 4.63 hours.