Introduction: Once I decided I was scratch building from aluminium, having something to bend sheet metal was essential, but buying a commercial brake wasn’t affordable, […]
Author: Glenn
Engine Mount
The Continental 0-200 mount is turning out to be a much more difficult proposition than I could’ve imagined. Several attempts to buy an already built […]
Flap Motor Pushrod
I bought a screw type flap motor from another builder who had upgraded to the newer linear actuator type. The motor came without an actuator […]
6ZU2-1 Top Doubler Re-make
After checking all of the new parts against the standard Centre Spar, I noticed quite a discrepancy (about 3mm) on the depth of the top […]
6ZU2-8 Rear Bottom Angle
Cut, fold and hammer to shape as per previous items. One thing I would recommend with these heavier 0.063 parts, is making the flanges well […]