Made the doubler by bending on the homebuilt brake as far as it would go, then finished off by hand.
I made up a 4 x 2 pine block with a 10 degree angle and 1/8″ round and although it took quite some time, the result was quite good.
Related Posts
6ZU2-7, 6ZU2-2
These parts folded on the brake, then finished off by hand on the form block as for the Top Doubler. This is a slow process, […]
6ZU2-8 Rear Bottom Angle
Cut, fold and hammer to shape as per previous items. One thing I would recommend with these heavier 0.063 parts, is making the flanges well […]
6ZU2-1 Top Doubler Re-make
After checking all of the new parts against the standard Centre Spar, I noticed quite a discrepancy (about 3mm) on the depth of the top […]